Plumbing/Drainage Fittings

The Smart-Ass is a cover plate for dishwasher hoses and power leads in cupboards at wall penetrations.

Guzzla smarTEEs are saddles that glue and screw onto existing 100mm stormwater pipes to enable a connection of 90mm s/w pipe simply by placing an 88mm holesaw inside the socket and cutting through. We have two sizes. This size, the smarTEE100 saddles on to 100mm pipe and branched into 90mm pipes. A great fitting - less time, effort and cost.

Guzzla smarTEEs are saddles that glue and screw onto existing stormwater pipes to enable a connection of 90mm s/w pipe simply by placing an 88mm holesaw inside the socket and cutting through. We have two sizes. This size, the smarTEE 90 suits a connection of 90mm to existing 90mm pipe. A great fitting - less time, effort and cost.

In Pipe 100 x 90 M&F Flanged Tank Adaptor

• Easy fit extended height overflow bend
• Use cheaper 90 F&F bends.
• 100 In Pipe flanged adaptor.
• Fit either way M or F.
• Adapts 90 to 100.

The Tee makes the junctioning of Agricultural pipe quick and easy. It can be used to junction pipe sizes such as 100mm Ag Pipe, 100mm Stormflex Pipe, and even 90mm PVC Pipe. When used with the Guzzla Blank / Reducer, it can even be used for junctioning 80mm Ag Pipe, 65mm Ag Pipe, and 50mm Ag Pipe.

The Temporary Down Pipe is the time efficient and cost effective answer to council requirements for environment protection sediment and erosion control - under pollution from building sites. This popular product increases production efficiency and safety for all trade aspects working in wet conditions. The downpipe comes as a plastic lay flat tube that measures about 200mm across, and comes in 170m or 17 lengths. TPD is also available to suit 150 mm downpipes.

Suggested fixing method:

1. At the downpipe drop in the gutter - roll your TDP over about 3 times like you would for the top of your socks. Slip it up over the drop and put 2 screws through the rolled TDP into the drop.
2.  At the stormwater pipe end you can insert a short piece of the same pipe which has been slit so you can compress it inside the TDP water pipe to hold it open at that point. One screw through should secure.
3. Alternatively a lot of builders now fix it in place using duct tape on both ends.

The Twist Plug is designed to be used as a blank that sits tightly in the corrugation at the end of your ag pipe or Stormflex pipe. It is really easy to install. Simply place the slit in the side of the plug over 

the end edge of your pipe that you wish to blank, then twist the plug around until it slips snug into the end of your pipe. The Twist Plug also comes in three different sizes, 65mm, 80mm and 100mm, to suit various agricultural pipes. It keeps brickies mud out of your Stormflex downpipe connections. Saves blockages and can be used time and time again.

Makes Grate Connections Easy to install with just 2 s/s screws (supplied) to suit the following pipes:

• 100 DWV Pipe - screw to (outside holes)

• 90mm SW Pipe - screw to (inside holes)

• 100 Agy Pipe - screw to (inside holes)

• 100 Stormflex Pipe - screw to (inside holes)

Keeps the frogs out of your pipes. To clean access, just undo the 2 screws to remove the entire grate, which gives you full access to the pipe