The Drainmaster 2.0 overcomes the difficulties Plumbers and Landscapers have with finishing heights and shallow stormwater pipes, the Drainmaster 2.0 only requires 60mm of earth over pipe to be used.
The large inlet maximizes water drainage efficiency, whilst maintaining the ability to be fixed to 90S/W and 100DWV pipes, using plumbers solvent cement.
The Drainmaster 2.0 retains the same strength qualities of the original Drainmaster, designed for pedestrian traffic through the use a strong grate design that is supported by 4 central pillars within the body.
The female flex Adaptor fits 90mm stormwater pipe directly to stormflex. She is great for 90mm downpipes going into storm flex drains. When the brickie cuts your Stormflex or the bobcat crushes it she will join up with the male flex adaptor for easy stormflex repairs. She is definitely a handy fitting to have from time to time.
The Male Flex Adaptor has been designed to provide an easy to use adaptor to connect Stormflex type pipe to any 90mm s/w fitting as well as inside any 100mm dwv pipe. You now have one fitting made for both 90mm and 100mm connections Makes using Flexible stormwater pipe so simple. It saves you Time and Money!!!
The In Pipe Finishing Collar suits 100mm DWV. Designed to fit existing pipes for easy repairs to damaged ORG openings.
Can be fitted at floor level for safety. (No trip) Solvent weld No need to remove plugs to install Termimesh barriers Remember when air testing to 4PSI, we recommend 2-3 hrs solvent cure time - cut upstand pipes and fit plugs at start of job to get maximum weld strength.
Can be fitted at floor level for safety. (No trip) Solvent weld No need to remove plugs to install Termimesh barriers Remember when air testing to 4PSI, we recommend 2-3 hrs solvent cure time - cut upstand pipes and fit plugs at start of job to get maximum weld strength.
Can be fitted at floor level for safety. (No trip) Solvent weld No need to remove plugs to install Termimesh barriers Remember when air testing to 4PSI, we recommend 2-3 hrs solvent cure time - cut upstand pipes and fit plugs at start of job to get maximum weld strength
The Loose Black Grate suits ORG collars. It has been designed for quick and easy replacement of damaged or old grates in existing ORG collars.
This fitting can be used to protect your drain from blockages which frequently occur where pipe exit points are left open to toads, snakes, frogs and rodents. Suits 100 DWV, 100 Agy Pipe and Stormflex pipe.
BSP x 100 x Recess 12mm makes a tidy finish when your 19 BP is short. Use centre plug in 19BP to guide 57mm holesaw.
The Guzzla Poly Surround for our ORG finishing collar, light weight, tough and whipper snipper resistant.
Your simple effective joiner for repairs and additions to stormwater pipes. We have a plain Slip Socket as well as one that has four brackets, which makes it very useful to secure to decks, etc., to locate 100mm pvc pipe in place.
Step 1. Slide socket on the pipe past the joint zone.
Step 2. Just glue both sides of joining pipes
Step 3. Then slip the socket over the glued joints quickly
while glue remains wet.
